Dancing LED

Aim:

The main aim of the project is to dance the LEDs with the help of sound sensor on TeBoT.

Components Required:

Sr. No	Component	Quantity
1	TeBoT and cable	1
2	Jumper Wires (M-F)	3
3	Sound Sensor	1

Connection and Code Upload:

Step 1: Connect the TeBoT with your device and turn on it.

Step 2: Select the board and port, then upload the code.

Warning: If you face any issue while uploading the code, first “OFF” the TeBoT. Next, turn “ON” the TeBoT. Press the “BOOT” button for a short time then press the “RESET” button once. Then release the “BOOT” button. You will get a drive. Then upload the code.

Step 3: Take the sound sensor and connect with TeBoT.

Sound Sensor ↔ TeBoT

VCC / + ↔ VCC (1^st pin from right to left in ultrasonic port)
GND / G ↔ GND (1^st pin from left to right in ultrasonic port)
DO ↔ Pin No 14 (2^nd pin from left to right in ultrasonic port)

Now turn on the TeBoT. When you create some sound close to sound sensor, the LEDs of TeBoT will glow like dance and it changes by changing sounds.

Conclusion: From this project we got the idea about all components, connection of those components and made the Dancing LED.