Fire Alarm

Aim:

The main aim of the project is to make the fire alarm on TeBoT.

Components Required:

Sr. No	Component	Quantity
1	TeBoT and cable	1
2	Jumper Wires (M-F)	3
3	Flame Sensor	1

Connection and Code Upload:

Step 1: Connect the TeBoT with your device and turn on it.

Step 2: Select the board and port, then upload the code.

Warning: If you face any issue while uploading the code, then first “OFF” the TeBoT. Next, turn “ON” the TeBoT. Press the “BOOT” button for a short time then press the “RESET” button once. Then release the “BOOT” button. You will get a drive. Then upload the code.

Step 3: Now take the Flame sensor and connect with TeBoT.

Flame Sensor ↔ TeBoT

VCC / + ↔ VCC (1^st pin from right to left in Ultrasonic Port)
GND / G ↔ GND (1^st pin from left to right in Ultrasonic Port)
DO ↔ Pin No 15 (3^rd pin from left to right in Ultrasonic Port)

Now, turn on the TeBoT. When you take flame close to the black LED of Flame sensor, the speaker will give a sound.

Conclusion: From this project we got the idea about all components, connection of those components and made the Fire Alarm.